Senior Electronics Design Engineer

Description

• Delivering fully verified and documented designs that meet project technical, schedule, and cost targets
• Managing component obsolescence and recommending suitable alternative components
• Designing analogue circuitry such as signal conditioning stages, filters, and op-amp-based solutions
• Collaborating with hardware, software, and firmware teams to ensure seamless integration of analogue/digital designs into broader systems
• Working with digital interface standards and protocols—including PCIe, USB, CAN bus, I²C, SPI, and Ethernet, to ensure system compatibility and high performance
• Creating component bias circuits
• Producing detailed analogue and digital circuit specifications, including component selection and circuit simulation
• Specifying, designing, developing, and testing electronic circuits and systems for telecommunications
• Undertaking design verification and validation activities, including preparing test specifications, test reports, and reliability evaluations in our on-site laboratories
• Keeping up to date with industry trends, emerging technologies and standards
• Actively participating in design reviews and initiating reviews when appropriate to mitigate risks
• Designing low-voltage module power supplies, including both linear and switch-mode PSUs
• Designing digital circuits using FPGAs, glue logic, ADCs, DACs, and microprocessors
• Performing schematic capture and defining circuit board requirements, including materials and layer stack
• Carrying out thermal analysis, MTBF assessments, component derating, and tolerance analysis
• Working closely with our RF engineering team, you will design advanced electronic circuits that integrate mixed technologies for telecommunications, satellite, and defence applications. You will be specifically responsible for:
• Supporting product introduction through problem-solving and fault diagnosis, including defining and training out diagnostic procedures
• Troubleshooting and resolving hardware and communication issues relating to digital circuits and interfaces
• Conducting system-level integration and testing to verify performance and reliability requirements

Requirements

• Familiarity with EMC/EMI design and testing
• Experience of RF / microwave electronic circuit design and implementation desirable
• Relevant Degree in Electronic Engineering (or equivalent).
• Demonstrable experience of component level electronic circuit design and development
• Experience in circuit schematic generation using Altium Designer is highly desirable
• Experience with test equipment such as oscilloscopes, mustimeters, spectrum analysers, and logic analysers
• Experience with software defined radio (SDR) systems desirable
• An awareness of high-volume surface mount process / technologies and design for high volume manufacture
• Experience with analogue and digital signal processing (DSP) techniques for RF applications

Benefits

Training + Development

Interview process

Visa Sponsorship

Security clearance