Controls Technician II

Description

• Startupof complete building control systems.
• Work closely with our installation subcontractors and coordinate work with them to ensure projects are completed on time as per code, standards and contract requirements.
• Perform low voltage cable installation/termination for small projects if needed.
• Install building control components(controllers, panels, conduit, sensors, etc.)
• Perform software/hardware calibration required for proper equipment and system operation.
• Service of existing building control systems.
• Take on project commissioning activities to include daily meetings and documenting results.
• Perform a point-to-point checkout per standard procedures.

Requirements

• Can work both independently and as a part of a team.
• Basic networking, ability to manipulate pc settings to access, set up and commission devices on a network.
• Troubleshooting skills, the ability to understand a problem and work toward reasonable solutions
• Understanding of Mechanical and Electrical equipment in a typical Data Center application
• Ability to visit job construction hard hat areas and climb stairs, climb ladders, maneuver in and around pipework and air ducts and work safely near exposed line voltage and low voltage wiring and terminations.
• Ability to own a task from beginning to end. Effectively communicating progress and/or issues about assigned task.
• Able to pass State and Federal security screening.
• Possess valid state motor vehicle license and possess safe driving record as required by company’s insurance carrier.
• Strong understanding of open protocols (For Example... BACnet IP/BACnet MSTP/Modbus TCP/Modbus RTU)
• Has had experience with BMS software, Tridium is preferred and understands wire sheet programming and logic.
• Maintain proper understandings of code requirements for indoor and outdoor electrical infrastructure, and knowledge of handling higher voltage (120, 240, 480V) for controls purposes
• Familiarity with CAD, construction drawings
• Basic proficiency in Microsoft suite (Word, Outlook, Visio, Excel, PowerPoint)
• Knowledge of terminating wire to terminal blocks to include RS-232, RS-485 and CAT 5/6
• Must be able to multi-task, it is very probable you will be assigned multiple tasks over multiple customers at any given time.
• Can read schematics (network topologies, electrical one-lines, device wiring drawings, control drawings, etc...)
• Out-of-state travel will be required (estimated to be between 25% - 30% throughout the year)

Benefits

Training + Development

Interview process

Visa Sponsorship

Security clearance